The design incorporates a 16-bit pass through PC/104 connector, molex type power input connector and voltage status LED’s. Since heat is always a factor to consider in any system design project, this module can be populated on either side of the board to facilitate heat sinking to one end of an enclosure, with the CPU heat sinking to the other end of the enclosure.
This single output version can be ordered with or without a heatsink. At up to 84% efficiency, a dynamic input range and full protection on inputs and outputs, this power supply is very versatile and appropriate for many PC/104 based applications.
The Input Power Connector is a Four-pin standard Molex type connector at the edge of the board. It’s the same connector as used on a CD-ROM so it’s easy to set up and test a system with a local 12V Computer type power supply.
Specifications
Output Characteristics
- OutputVoltage Set Point on 5V: ±1%, Factory set
- Load Regulation: ±0.5%, Measured from Full Load to 10% load
- Temperature Coeffcient: ±0.01%/°C
- Ripple/Noise on 5V: 60mV P-P measured at 20MHz bandwidth
- Short Circuit Protection: Indefinite, Automatic Recovery
- Overvoltage Protection: 120% Clamp type
Input Characteristics
| Input Characteristics |
12 |
24 |
48 |
Unit/Comments |
| Input Voltage |
9-18 |
18-36 |
36-75 |
VDC |
| Under Voltage Shut Down |
8 |
16 |
33 |
VDC (min) |
| Over Voltage Shut Down |
20 |
40 |
80 |
VDC (max) |
| Minimum Input Current |
0 |
0 |
0 |
A (min) |
| Full Load Input Current |
3.2 |
2.0 |
1.0 |
A (max) |
| Effciency by Model |
81 |
83 |
84 |
% |
| Swtiching Frequency |
360 to 440 |
KHz, Factory set |
| Operating Tempurature |
-40 to 65 |
°C, up to 105°C with derating of 2% per °C (no air flow) |
| Storage Temperature |
-55 to 125 |
°C |
| Relative Humidity |
5 to 95 |
%, non-condensing |
CE testing & approval must be done at the system level, in the designed enclosure, and is not done on individual boards.
| Part Number |
Price(USD) |
| 104-PWR-500A-12 |
129.00 |
| 104-PWR-500A-24 |
129.00 |
| 104-PWR-500A-48 |
129.00 |
NOTE - Specify "-HS" as a suffix for heat sink version. Specify "-R" for population of DC/DC converter on reverse side of board.
