6407 Specifications

Oscilloscope — Vertical
Model	PicoScope 6407 (PP795)
Bandwidth (-3 dB)	1 GHz
Rise time (calculated)	350 ps
Input channels	4
Vertical resolution	8 bits
Enhanced vertical resolution	12 bits
DC accuracy	±3%
Input sensitivity	20 mV/div
Input impedance	50 Ω ±2%
Input type	SMA
Input coupling	DC
Input ranges (full scale)	±100 mV
Overvoltage protection	±2 V (DC Peak AC)

Oscilloscope — Horizontal
Maximum sampling rate (single shot) 1 channel in use 2 channels in use 3 or 4 channels in use	5 GS/s 2.5 GS/s (using A C, A D, B C, B D) 1.25 GS/s
Maximum sampling rate (continuous streaming mode)	1 MS/s using PicoScope >10 MS/s using the supplied SDK (PC dependent)
Buffer memory (shared between active channels)	1 GS
Waveform buffer	Up to 10,000 waveforms
Timebase accuracy	±5 ppm

Dynamic Performance (typical)
Crosstalk DC to 100 MHz 100 MHz to 1 GHz	100:1 30:1
Step response	±3% after 3 ns, typical
Noise	<0.5 mV RMS

Triggers
Basic triggers	Rising, falling
Advanced triggers	Edge: single edge or dual edge; adjustable hysteresis Pulse width: negative or positive pulse; wider or narrower than a specified width Window: entering or leaving a voltage range Dropout: inactivity over a user–defined time interval Window dropout: signal does not enter or exit a voltage range for at least a set time Interval: time between two edges is greater or less than a set time, or inside/outside a time range Logic level: arbitrary logic state of Channels A, B, C, D and AUX Runt pulse: crosses one threshold but not the other
Trigger modes	Edge, pulse width, dropout, interval, logic, delayed
Maximum trigger rate	Up to 10,000 waveforms in a 20 ms burst
Trigger sources	Channels A to D, AUX
Trigger level	Adjustable over whole of selected voltage range
Re–arm time	<1 µs on fastest timebase
Maximum trigger delay pre–trigger post–trigger	Up to 100% of capture duration Up to 4 billion samples

Auxiliary Trigger/Reference Clock Input (AUX)
Input type	Rear panel BNC
Input impedance	50 Ω ±1%
Input coupling	DC
Voltage range	±5 V
Bandwidth (AUX TRIGGER)	25 MHz
Input threshold	±1 V
Overvoltage protection	±5 V
Frequency range (CLOCK INPUT)	5 MHz to 25 MHz

Signal generator
Standard output waveforms	Sine, square, triangle, ramp (up/down), sin (x)/x, Gaussian, half–sine, white noise, PRBS, DC level
Frequency range	DC to 20 MHz
Output frequency accuracy	±5 ppm
Output voltage range (peak to peak)	±250 mV to ±2 V (into high impedance load)
Offset voltage adjustment	±1 V (maximum combined output ±2.5 V)
Amplitude flatness	1.5 dB DC to 20 MHz, typical
Connector type	Rear panel BNC
Overvoltage protection	±5 V
Sweep modes	Up, down, dual with selectable start/stop frequencies and increments

Arbitrary Waveform Generator
Sample rate	200 MS/s
Buffer size	16,384 samples
Resolution	12 bits
Bandwidth	20 MHz
Rise time (10 – 90%)	10 ns, typical

PC Requirements
Minimum	Processor: Pentium II processor, or equivalent Memory: 64 MiB (XP) / 512 MiB (Vista) / 1 GiB (Win 7) Operating system: 32– or 64–bit edition of Microsoft Windows XP SP2, Vista or Windows 7 Ports: USB 2.0 compliant port
Recommended	Processor: 2 GHz Pentium IV processor, or equivalent Memory: 256 MiB (XP) / 1 GiB (Vista / Win 7) Operating system: 32– or 64–bit edition of Microsoft Windows XP SP2 (or above), Vista or Windows 7 Ports: USB 2.0 compliant port

Environmental
Operating environment Temperature range	0 °C to 40 °C (20 °C to 30 °C for quoted accuracy)
Storage environment Temperature range Humidity	-20 °C to 60 °C 5% to 95% RH, non–condesning
IP rating	IP 20

Physical Properties
Dimensions	255 x 170 x 40 mm (approx 10 x 6.7 x 1.6 in)
Weight	<1 kg (approx 2 lb 2 oz)

Software

PicoScope 6 for Windows

PicoScope 6 is your complete test and measurement lab in one application. Features include:
Capture modes: oscilloscope, spectrum and persistence.
Channel maths: calculate the sum, difference, product, inverse or create your own custom function using standard arithmetic, exponential and trigonometric functions.
Mask limiting testing: pass/fail, failure count, total count.
Serial Decoding: decode data from a serial bus such as I²C.
Automated measurements
Scope mode: AC RMS, true RMS, cycle time, DC average, duty cycle, falling rate, fall time, frequency, high pulse width, low pulse width, maximum, minimum, peak–to–peak, rise time and rising rate.
Spectrum mode: frequency at peak, amplitude at peak, average anplitude at peak, total power, total harmonic distortion (THD % and THD dB), total harmonic distortion plus noise (THD N), spurious-free dynamic range (SFDR), signal noise distortion to signal noise ratio (SINAD), signal to noise ratio (SNR) and intermodulation distortion (IMD).
Export data formats: comma separated values (CSV), tab delimited (TXT), windows bitmap (BMP), graphics interchange format (GIF), portable network graphics (PNG), MATLAB 4 format (MAT).
Full details for PicoScope 6

Software development kit

Includes drivers and example code for various programming languages including C, Excel and LabVIEW.

Language Support
Software PicoScope 6	Full support for: English, Français, Deutsch, Italiano, Español Menus and dialogs only for: 中文 (简体), 正體中文 (繁體), Čeština, Dansk, suomi, Ελληνικά, Magyar, 日本語, Norsk, Polski, Português, română, Русский, Svenska, Türkçe
Documentation User’s guide Programmer’s guide Quick Start Guide	English English English, Français, Deutsch, Italiano, Español

General
Data sheet	English, 中文 (简体), Deutsch, Español, Français, Italiano
Additional hardware (supplied)	USB 2.0 cable, carry case, user manuals and software CD–ROM
PC interface	USB 2.0
Power supply AC adaptor	12 V ±2 V @ 3.5 A External adaptor supplied (suitable for USA, UK, Europe and Australasia)
Compliance	European EMC and LVD standards FCC Rules Part 15 Class A RoHS compliant
Total Satisfaction Guarantee	In the event that this product does not fully meet your requirements you can return it for an exchange or refund. To claim, the product must be returned in good condition within 14 days.
Warranty	5 years
Price	Buy PP795 online

Note: quoted specifications apply when using PicoScope 6 software.
Need to know a specification not listed here? — just ask

PicoScope 6407 USB Oscilloscope Specifications